MiniMed

The tube is conical without a "skirt" of stability, designed for centrifugation of biological and other liquids. The test tube is closed with a screw cap. The divisions are applied with white paint. There is also a field for recording. The conical tube is made of polypropylene, which allows it to be autoclaved in standard mode.

Designed for centrifugation of biological and other liquids. The tube is conical graduated with a window for recording and a screw cap. The calibration on the test tube is applied with white paint, resistant to erasure. The test tube is made of polypropylene, which allows it to be autoclaved in standard mode. Relative centrifugal acceleration9000d

The test tube is intended for the selection, storage and transportation of biomaterial samples for further diagnostic studies in clinical laboratories. Made of polypropylene. No traffic jam. It has a circular calibration to determine the approximate volume 0,5-1,0-2,5-5,0-10,0 ml.

The polymer tip is suitable for most modern dispensers of the Lenpipet,Finpipette, Gilson, Eppendorf, Socorex brands. With a filter. Non-sterile.

The polymer tip is suitable for most modern dispensers of the Lenpipet,Finpipette, Gilson, Eppendorf, Socorex brands. With filter, non-sterile.

The cup is made of translucent polypropylene. Non-sterile. Combines the advantages of glass and polystyrene cups. Its reusable sterilization in an autoclave is possible (+121 ° C), and, at the same time, the product has a small weight and is less fragile than glass and polystyrene. Suitable for sanitary microbiological studies in research laboratories. Ventilated.

The test tube is intended for the selection, storage and transportation of biomaterial samples for further diagnostic studies in clinical laboratories. Made of polystyrene. No traffic jam. It has a circular calibration to determine the approximate volume 0,5-1,0-2,5-5,0-10,0 ml.

It is intended for filling with a solution (chemical reagents, reagents, biological fluids, etc. in concentrations used in clinical and diagnostic laboratories, with the exception of concentrated organic solvents) with the subsequent selection of this solution by dispensers during diagnostic studies in medical and preventive and research laboratories. Made of polystyrene. The bath for multichannel dispensers is a non-sterile product of single use. ON THE OTHER 22.29.29-026-29508133-2017 , 60 ml, p/s, pack.5/30pcs, minimal.

It is intended for filling with a solution (chemical reagents, reagents, biological fluids, etc. in concentrations used in clinical and diagnostic laboratories, with the exception of concentrated organic solvents) with the subsequent selection of this solution by dispensers during diagnostic studies in medical and preventive and research laboratories. Made of polystyrene. The bath for multichannel dispensers is a non-sterile product of single use. ON THE OTHER 22.29.29-026-29508133-2017 , 30 ml, white, p/s, MiniMed, pack.15pcs/300pcs

Designed for dosing of various solutions. It consists of a bottle with a narrow neck and a lid with a dropper (with a long spout and a removable cap on the chord). It has a relief graduation. The length of the spout is 40 mm. Made of polyethylene. It is not subject to autoclaving.

Designed for dosing of various solutions. It consists of a bottle with a narrow neck and a lid with a dropper (with a long spout and a removable cap on the chord). It has a relief graduation. The length of the spout is 40 mm. Made of polyethylene. It is not subject to autoclaving.

It is intended for cultivation of microorganisms on dense and nutrient media. Withstands chemical and thermal sterilization modes. Made of glass of the brand NSTU 9464-021-29508133-2016. GOST 25336-82. RU No. RZN 2017/5746 dated 13.11.2017