A set of BNTI devices-05-04- 4K

Allows you to install and securely fix up to 6 verifiable thermometers with a diameter of the submerged part from 9 to 16 mm. The design of the holder eliminates damage to glass thermometers. It is designed for calibration thermostats THERMOTEST-100 and THERMOTEST-300.

It is used to determine the corrosive effect of engine fuels on a copper plate in accordance with GOST 6321

It is intended for placement in the BF bath and is used in determining the mass fraction of paraffins in oil in accordance with the method A of the State Standard 11851.

It is used in determining the pour point of petroleum products in accordance with the State Standard 20287 (method B).

A set of devices is used to determine the oil content in oil paraffins in accordance with the State Standard 9090 and is intended for placement in a liquid bath BNTI 05 04.

It is used for testing in accordance with GOST 12801, GOST 11501, GOST 33136 and GOST 11505.

If you are going to use an electronic thermometer LT 300, LT or LTA not in the laboratory, but in the non-laboratory condiditions, this durable case with a lid will protect the sensor from damage. The size of the case is determined by the length of of your thermometer.

It is designed for simultaneous polishing of four copper plates measuring 75×12.5×2 mm used in determining the corrosive effect of fuels in accordance with GOST ISO 2160, GOST 32329, GOST 6321, GOST 2917 and ASTM D130.

The spring holder for LT 300 or LT electronic thermometers allows you to simply and securely mount the temperature sensor on the walls of laboratory utensils so that it does not touch either its bottom or the wall. This allows temperature measurements to be carried out not only conveniently, but also correctly.

The holder with flat steel springs allows you to install and securely fix up to 6 verifiable thermometers with a diameter of the submerged part from 9 to 16 mm. It is designed for THERMOTEST 05 and THERMOTEST-05-1 thermostats.

It is used for determining the low-temperature characteristics of petroleum products in accordance with the State Standard 20287 (Method A), EN 23015 and ASTM D97

It is used in determining the density of petroleum products, resins, plasticizers and other chemical products by hydrometers in stainless steel cylinders with a height of 300 mm and internal diameters of 60.5 and 73 mm.

The holder with flat steel springs allows you to install and securely fix up to 6 verifiable thermometers with a diameter of the submerged part from 16 to 20 mm. It is designed for calibration thermostats THERMOTEST-100 and THERMOTEST-300.

It is used in determining the flow temperature of petroleum products in accordance with GOST 20287 (method A). For testing, additional sets of devices BNTI 05 04 K and BNTI 05 04 3K are required

It is used for testing in accordance with the State Standart 12801, GOST 11501, GOST 33136 and GOST 11505.

It is used in determining the low-temperature characteristics of petroleum products and organic chemical products in accordance with the State Standard 5066 (Method B) and GOST 18995.5.